Product Description

• Latching Type: Push it - ON, push it again - OFF
• With the connector, makes switch installation a breeze
• Switch Contacts: 1NO1NC, you can use NO to control, press the button to breakover. You can also use NC to control, press the button to power off
• IP67 Waterproof & IK10 Protection: Rustproof, can be used in wet or dusty environment
• Used widely: Great for Electric Switch, Relay, Power Button Switch, Door Switch or any circuit controls
•  
• Product description
• Switch: 
  These metal buttons are rugged and look real good while doing it! Simply drill a 30mm hole into any material and you can fit these in place, there's even a rubber gasket to keep water out of the enclosure.
  
  On the front of the button is a high flush actuator, easy to press. On the back there are 3 terminals for the button. NC= Normal Close, NO= Normal Open, C= Common. Usually use Normal Open to control, press the button to breakover. Of course, you can also use Normal Close to control, press the button to power off.
  
  The latching button is rated up to 5A/250VAC. As long as you don't exceed the rating amps and volts, it can run anything.
  
  Latching Switch: 
  Latching switch will latch into place, maintaining their state until pressed again latching back to where the started.
  These latching buttons are perfect for Power Button Switch or any circuit controls. Also great for electronic DIY projects.
  
  Note: 
  *These switches come with a rubber O-ring which makes them splash resistant but they can NOT be submerged in the water. 
•